LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> RX 400h AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 311 (Audio System & Visual System) >> Steering Pad Switch >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Pad Switch: Installation

WARNING: This page is about a different car, the 2008 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See PRECAUTION ).
  1. INSTALL STEERING PAD SWITCH 
    1. Engage the 2 claws and the pin and install the steering pad.
      2. Fig 1: Identifying Steering Pad Switch Connector And Steering Pad Switch Screw
      G05114167Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Tighten the screw.

      Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf) 

    3. Connect the connector.
    4. w/ Cruise Control System:
      1. Connect the cruise control switch connector.
  2. INSTALL STEERING PAD  (See INSTALLATION )
  3. INSTALL STEERING WHEEL LOWER COVER LH  (See DISPOSAL )
  4. INSTALL STEERING WHEEL LOWER COVER RH  (See DISPOSAL )
  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

  6. INSPECT SRS WARNING LIGHT 

    (See DIAGNOSIS SYSTEM )

scientia non olet · About LEMON Manuals