LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> RX 400h AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 316 (Cruise Control System) >> Cruise Control System >> Data List / Active Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List / Active Test

WARNING: This page is about a different car, the 2008 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. READ DATA LIST 

    HINT:

    Using a Techstream to read the DATA LIST allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.

    NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
    1. Connect a Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the tester ON.
    4. Enter the following menus: Powertrain / Cruise Control / Data List.
    5. According to the display on tester, read the "DATA LIST".

      ECM (Cruise Control) 

      MEASUREMENT ITEM/RANGE CHART

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      CCS Vehicle Spd Vehicle speed / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) Actual vehicle speed -
      CCS Main Vehicle Spd Vehicle speed / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) Actual vehicle speed stored in memory -
      Cruise Request Torque Cruise control request torque / min.: -1,024 Nm, max.: 1,016 Nm Actual required torque -
      Cruise Control Cruise control / ON or OFF ON: Cruise control is SET
      OFF: Cruise control is UNSET      		 -
      CCS Main SW M-CPU Main switch (Main CPU) / ON or OFF ON: Main switch (Main CPU) is SET
      OFF: Main switch (Main CPU) is UNSET      		 -
      CCS Ready M-CPU Switch ready (Main CPU) / ON or OFF ON: Switch ready (Main CPU) is SET
      OFF: Switch ready (Main CPU) is UNSET      		 -
      CCS Indicator M-CPU Switch indicator (Main CPU) / ON or OFF ON: Switch indicator (Main CPU) is SET
      OFF: Switch indicator (Main CPU) is UNSET      		 -
      Cancel Switch CANCEL switch / ON or OFF ON: CANCEL switch is SET
      OFF: CANCEL switch is UNSET      		 -
      SET/COAST Switch - / SET switch / ON or OFF ON: - / SET switch is SET
      OFF: - / SET switch is UNSET      		 -
      RES/ACC Switch + / RES switch / ON or OFF ON: + / RES switch is SET
      OFF: + / RES switch is UNSET      		 -
      Stp Light SW M-CPU Stop light switch signal (Main CPU)/ON or OFF ON: Brake pedal depressed
      OFF: Brake pedal released      		 -
      Cruise Operation Status Cruise control / ON or OFF ON: Cruise control is SET
      OFF: Cruise control is UNSET      		 -
      # Codes Number of diagnosis codes/Min.: 0, Max.: 255 - -
scientia non olet · About LEMON Manuals