LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> RX 400h AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 332 (Brake Control) >> Steering Angle Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Angle Sensor: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STEERING ANGLE SENSOR 
    1. Align the locating pins, attach the 6 claws and install the sensor to the spiral cable.
    Fig 1: Identifying Steering Angle Sensor Claws
    G05585125Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY  (See INSTALLATION )
  3. INSTALL STEERING COLUMN COVER  (See INSTALLATION )
  4. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  5. INSTALL STEERING PAD ASSEMBLY  (See INSTALLATION )
  6. INSPECT STEERING WHEEL CENTER POINT 
  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When reconnecting the cable to the negative (-) battery terminal after installing the steering angle sensor, check that the front tires and steering wheel are kept aligned straight ahead before and after connecting the cable to the negative (-) battery terminal.
  8. INSPECT STEERING PAD ASSEMBLY  (See DISPOSAL )
  9. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).
scientia non olet · About LEMON Manuals