Service Data
WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
2UZ-FE STARTING SERVICE DATA
| No-load characteristics | Current: 100 A or less at 11.5 V |
|---|---|
| Starter armature assembly | Maximum runout: 0.05 mm (0.002 in.) |
| Standard diameter: 35.0 mm (1.378 in.) | |
| Minimum diameter: 34.0 mm (1.339 in.) | |
| Standard undercut depth: 0.7 mm (0.028 in.) | |
| Minimum undercut depth: 0.2 mm (0.008 in.) | |
| Starter yoke assembly | Terminal - Terminal: 1.5 to 1.9 Ω |
| Brush length | Standard: 15.0 mm (0.591 in.) |
| Minimum: 9.0 mm (0.354 in.) | |
| Brush spring load | Standard: 21.5 to 27.5 N (2.2 to 2.8 kgf, 4.8 to 6.2 lbf) |
| Minimum: 12.7 Nm (1.3 kgf, 2.9 lbf) | |
| Starter relay | 3 - 5: 10 kΩ or higher |
| 3 - 5: Below 1 Ω (when battery voltage is applied to terminals 1 and 2) | |
| ACC relay | 3 - 4: Below 1 Ω |
| 3 - 5: 10 kΩ or higher | |
| 3 - 4: 10 kΩ or higher (when battery voltage is applied to terminals 1 and 2) | |
| 3 - 5: Below 1 Ω (when battery voltage is applied to terminals 1 and 2) | |
| Ignition switch | LOCK: Between all terminals 10 kΩ or higher |
| ACC: 2 (AM1) - 3 (ACC) Below 1 Ω | |
| ON: 2 (AM1) - 3 (ACC) Below 1 Ω | |
| ON: 2 (AM1) - 4 (IG1) Below 1 Ω | |
| ON: 6 (IG2) - 7 (AM2) Below 1 Ω | |
| START: 1 (ST1) - 2 (AM1) Below 1 Ω | |
| START: 1 (ST1) - 4 (IG1) Below 1 Ω | |
| START: 6 (IG2) - 7 (AM2) Below 1 Ω | |
| START: 6 (IG2) - 8 (ST2) Below 1 Ω |