Section 65 (Charging System): Generator: Replacement

WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

REPLACE GENERATOR DRIVE END FRAME BEARING
1. Remove the 4 screws, bearing retainer and bearing.
  
  Fig 1: Removing Bearing Retainer & Bearing Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST and a hammer, tap out the bearing.
  SST 09950-60010 (09951-00250), 09950-70010 (09951-07100)
  
  Fig 2: Tapping Out Bearing Using SST & Hammer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST and a press, press in a new bearing.
  SST 09950-60010 (09951-00250), 09950-70010 (09951-07100)
  
  Fig 3: Pressing In New Bearing Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the bearing retainer with the 4 screws.
  Torque: 2.3 N*m (23 kgf*cm, 20 in.*lbf)
  
  Fig 4: Installing Bearing Retainer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002