Control Valve Assembly: Removal

WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CONNECTOR
DISCONNECT ACTIVE HEIGHT CONTROL FLUID LINE
1. Using SST, disconnect the 5 active height control lines.
  SST 09023-00101
  
  Torque: 15 N*m (155 kgf*cm, 11 ft.*lbf)
REMOVE NO. 1 HEIGHT CONTROL VALVE ASSEMBLY
1. Remove the 3 nuts and control valve assembly.
  Torque: 5.5 N*m (55 kgf*cm, 48 in.*lbf)
2. Remove the 3 holders, 3 cushions and 3 cushion bolts from the control valve assembly.
  Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf)
  
  Fig 1: Disconnecting Active Height Control Lines
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the 4 bolts and cover.
  Torque: 4.4
  
  N*m (45 kgf*cm, 38 in.*lbf)
4. Remove the gasket.
  HINT:
  
  At the time of installation, replace the used gasket with a new one.