LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> RX 400h AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Engine Ignition System) >> VVT Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

VVT Sensor: Installation

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL VVT SENSOR (for Bank 1) 
    1. Install the sensor with the bolt.

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

    2. Connect the connector.
  2. INSTALL VVT SENSOR (for Bank 2) 
    1. Install the sensor with the bolt.

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

    2. Connect the connector.
  3. INSTALL INTAKE MANIFOLD ASSEMBLY 
    1. Install the intake manifold assembly (see INSTALLATION ).
  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  5. ADD ENGINE  COOLANT 
  6. CHECK FOR ENGINE COOLANT LEAKS 
    1. Check for the engine coolant leaks (see COOLING SYSTEM ).
  7. PERFORM INITIALIZATION 
    1. Perform INITIALIZATION .
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
scientia non olet · About LEMON Manuals