How To Proceed With Troubleshooting

HINT.

• Use the following procedure to troubleshoot the cruise control system.
• *: Use the Techstream

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard Voltage: 11 to 14 V 

   If the voltage is below 11V, replace or recharge the battery before proceeding.

3. CHECK COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)* 
   1. Use the Techstream to check if the multiplex communication system (MPX) is functioning normally.

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      MPX DTC is not output	A
      MPX DTC is output	B

   B: GO TO MULTIPLEX COMMUNICATION SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

   A: Go to next step 

4. CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)* 
   1. Use the Techstream to check if the CAN communication system is functioning normally.

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

   B: GO TO CAN COMMUNICATION SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

   A: Go to next step 

5. CHECK FOR DTC* 

   Refer to DTC CHECK / CLEAR  .

   1. Check for DTCs and note any codes that are output.
   2. Clear the DTCs.
   3. Recheck for DTCs. Try to prompt the DTCs by simulating the original activity that the DTCs suggest.

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      DTC does not reoccur	A
      DTC reoccur	B

   B: Go to step  8

   A: Go to next step 

6. PROBLEM SYMPTOMS TABLE 

   Refer to PROBLEM SYMPTOMS TABLE  .

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B: Go to step  8

   A: Go to next step 

7. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Terminals of ECM (See TERMINALS OF ECM  )
   2. Data List / Active Test (See DATA LIST / ACTIVE TEST  )
8. ADJUST, REPAIR OR REPLACE 
9. CONFIRMATION TEST 

   NEXT: END