LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> IS F >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel >> Fuel Pressure Sensor >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Fuel Pressure Sensor: Removal

  1. PRECAUTION 
    CAUTION:
    • Do not smoke or work near an open flame when handling the fuel system.
    • Keep gasoline away from rubber or leather parts.
    • Do not allow fuel to spray when removing the pipe between the high pressure side fuel pump assembly and the fuel injector assembly. The fuel in the pipe is highly pressurized.
  2. DISCHARGE FUEL SYSTEM PRESSURE 
    1. Discharge fuel system pressure (See FUEL SYSTEM ).
  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  4. REMOVE INTAKE AIR SURGE TANK ASSEMBLY 
    1. Remove the intake air surge tank assembly (See REMOVAL ).
  5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE FUEL PRESSURE SENSOR 
    1. Disconnect the connector.
    2. Remove the fuel pressure sensor and gasket
      3. Fig 1: Locating Fuel Pressure Sensor And Connector
      G04947995Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals