Inspection Procedure

1. Check if the "Bluetooth" settings are correct.

   OK: "Bluetooth" settings are correct. 

NG: SET SETTINGS CORRECTLY 

OK: Go to Next Step 

1. Check if the cellular phone is "Bluetooth" compatible.

   HINT:

   Some versions of "Bluetooth" compatible cellular phones may not function.

   OK: Phone is "Bluetooth" compatible. 

NG: END (ONLY A "BLUETOOTH" COMPATIBLE CELLULAR PHONE CAN BE USED) 

OK: Go to Next Step 

1. Check if the cellular phone functions.

   HINT:

   The cellular phone is unable to call under any of the following conditions.

   • The cellular phone is locked.
   • The directory is being transferred.
   • The line is crossed.
   • Transmission is regulated.
   • The engine is off.
   • The cellular phone is not connected to "Bluetooth" ("Bluetooth" mark is displayed while connected).

   OK: Above conditions do not exist. 

NG: SET CORRECTLY 

OK: Go to Next Step 

1. Check if the cellular phone can make calls.

   HINT:

   When the battery is low, calls cannot be made or received.

   OK: Cellular phone can make calls. 

NG: REPLACE CELLULAR PHONE 

OK: Go to Next Step 

1. Set the cellular phone so that it can receive calls.
2. Place the cellular phone close to the display and navigation module display.
3. Check if the cellular phone has reception according to the display and navigation module display.

   OK: Cellular phone has reception. 

NG: REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY  (See REMOVAL  )

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE  )