Section 24 (Charging): Generator: Installation

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL GENERATOR ASSEMBLY
1. Install the generator with the 2 nuts and bolt.
  Torque: 39 N*m (398 kgf*cm, 29 ft.*lbf) for bolt and nut A
  
  15 N*m (153 kgf*cm, 11 ft.*lbf) for nut B
2. Connect the engine wire bracket with the bolt.
  
  Fig 1: Locating Engine Wire Bracket With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL VANE PUMP PULLEY
1. Using SST, install the vane pump pulley with the nut.
  SST 09960-10010
  
  Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)
INSTALL FAN AND GENERATOR V BELT (See INSTALLATION )
INSTALL ENGINE UNDER COVER
INSTALL V-BANK COVER (See INSTALLATION )

Fig 2: Identifying Vane Pump Pulley With Nut
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 AIR CLEANER INLET (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.