Installation [11/2021 - ]: Procedure

Refer to INSPECTION [11/2021 - ] 

NOTE: Make sure that the wire harness is not interfering with the steering column assembly. HINT: As the illustration shown is an example, the actual details may differ.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Install the steering column assembly with the bolt and 2 nuts.

      Torque: 36 N.m (367 kgf/cm, 27 ft.lbf) 

      NOTE:

      After temporarily tightening the bolt, fully tighten the 2 nuts then fully tighten the bolt.

   2. Connect each connector and engage each wire harness clamp to the steering column assembly.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Matchmark	-	-
   	Install in this direction	-	-

   1. Align the matchmarks on the steering intermediate shaft assembly and steering column assembly.
   2. Install the steering intermediate shaft assembly to the steering column assembly.
   3. Install the bolt.

      Torque: 35 N.m (357 kgf/cm, 26 ft.lbf) 

   4. Tighten the clamp.

Refer to INSTALLATION [11/2021 - 03/2023] , or refer to INSTALLATION [03/2023 - ]

Refer to INSTALLATION [11/2021 - ]

NOTE: Do not remove/install the spiral cable with sensor sub-assembly with the auxiliary battery connected and the ignition switch ON. Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the auxiliary battery connected and the ignition switch ON. Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor. HINT: As the illustration shown is an example, the actual details may differ.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Clamp

   -

   -

   1. Using pliers, expand the clamp.
   2. While holding the clamp expanded, install the turn signal switch assembly with spiral cable sub-assembly to the steering column assembly and engage the claw.
   3. Return the clamp to its original position.
   4. Connect the connectors to the turn signal switch assembly with spiral cable sub-assembly.

Refer to INSTALLATION [11/2021 - ] 

Refer to REGISTRATION [11/2021 - 03/2023] , or refer to REGISTRATION [03/2023 - ]

1. Set the auto tilt away function setting to the previous condition by changing the customize parameter.

   Refer to CUSTOMIZE PARAMETERS [11/2021 - ]