Selector Lever Component Inspection

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the center console.
Remove the dashboard completely.
(See DASHBOARD REMOVAL/INSTALLATION .)
Disconnect the selector lever component connector.
Inspect for continuity at the selector lever component.
- If not as specified, adjust the selector cable.
  See SELECTOR CABLE ADJUSTMENT .
Fig 1: Selector Lever Connector Terminal Continuity Inspection Table
Courtesy of MAZDA MOTORS CORP.

Fig 2: Identifying Terminals Of Selector Lever Connector
Courtesy of MAZDA MOTORS CORP.