LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2000 >> Protege DX, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls - Self-Diagnostics - 1.6L >> Diagnostic Trouble Code Tests >> DTC P0452: EVAP System, Pressure Sensor Low Input >> Diagnosis & Repair Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair Procedure

  1. Ensure FREEZE FRAME PID data has been recorded. Check service bulletins. Go to next step.
  2. Using scan tool, access PID/DATA MONITOR. Start engine. Record PID data for FTP V. If data is less than .2 volt, go to next step. If data is more than .2 volt, problem is intermittent (not current).
  3. Disconnect FTP sensor connector. If PID data for FTP V is more than 4.8 volts, go to next step. If FTP V is 4.8 volts or less, go to step  5 .
    NOTE: If DTC P0107 and P0122 are present, check reference voltage. See REFERENCE VOLTAGE TEST  .
  4. Turn ignition off. Disconnect fuel tank pressure sensor connector. Turn ignition on. Measure voltage between ground and terminal "C" (Light Green/Red wire) on harness connector. If 4.5-5.5 volts is not present, go to next step. If 4.5-5.5 volts is present, check harness connector and FTP sensor terminal "C". Clean or repair as necessary. If no problem is found, replace fuel tank pressure sensor. Go to step  6 .
  5. Turn ignition off. Disconnect PCM harness connector. Check continuity between PCM harness connector No. 2 terminal "A" and ground. If continuity is present, repair short to ground on Red/Green wire. Go to next step. If continuity is not present, check for short on Black/Red wire and Light Green/Red wire between PCM and FTP sensor. Repair as necessary and go to next step.
  6. Turn ignition on. Erase DTC. See CLEARING CODES in SELF-DIAGNOSTICS - INTRODUCTION - MIATA, MILLENIA, MPV & PROTEGE article. Start engine. Using scan tool, access PID/DATA MONITOR. Check PID data for FTP V. FTP V should be .2-4.8 volts. Check for DTCs. If same DTC is pending, replace PCM. If DTC is not pending, go to next step.
  7. Reconnect all connectors. Erase DTC. See CLEARING CODES in SELF-DIAGNOSTICS - INTRODUCTION - MIATA, MILLENIA, MPV & PROTEGE article. If any DTC is present, go to appropriate test. If no DTC is present, test is complete.
scientia non olet · About LEMON Manuals