| 1 |
PERFORM ADDITIONAL KEY PROGRAMMING
- Connect the M-MDS to the DLC-2.
(See
M-MDS CONNECTING PROCEDURE )
- Turn the ignition switch to the ON position using key 1.
NOTE:
- Although the security light starts flashing and DTC 15 is displayed after approx. 1 min
, this does not indicate an improper procedure. Continue to perform the procedure as indicated.
- After vehicle identification, select the following from the M-MDS initial screen.
- Using an IDS (laptop PC)
- Select the "Body"
- Select the "Security"
- Select the "PATS Functions"
- Using a PDS (Pocket PC):
- Select the "All Tests and Calibrations"
- Select the "PATS Functions"
- Select "Program Additional Ignition Key" from the M-MDS screen menu.
- Perform the security access according to the directions on the M-MDS screen. (See
SECURITY ACCESS PROCEDURE .)
NOTE:
- After executing the above menu, 'This operation is successful" is displayed. This indicates that the programming of the key currently in the ignition switch ON position has been completed.
- After verifying that the PATS function menu is displayed again on the M-MDS screen, turn the ignition switch to the LOCK position.
- Remove key 1.
- Are there other keys to be programmed?
|
Yes |
Change the key and repeat Step 1.
NOTE:
- Additional key programming can be performed using the procedure in No. 1 Additional Key Programming Procedure (Using Two Valid Keys).
|