LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2010 >> 5 Touring, 2.3 L >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security System And Locks System >> Immobilizer System Component Replacement/Key Addition And Clearing [Keyless Entry System] >> No. 5 Programming Procedure Due to Instrument Cluster Replacement >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

No. 5 Programming Procedure Due to Instrument Cluster Replacement: Procedure

Fig 1: Identifying Valid Key
G06726227Courtesy of MAZDA MOTORS CORP.
PROGRAMMING PROCEDURE

Step Procedure Action after procedure
1 REPLACE INSTRUMENT CLUSTER 
Refer to Instrument cluster removal/installation to perform instrument cluster replacement and configuration.
(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
(See INSTRUMENT CLUSTER CONFIGURATION .)		 Go to the next step.
2 PERFORM PARAMETER RESET 
  1. Connect the M-MDS to the DLC-2.

    (See M-MDS CONNECTING PROCEDURE .)

  2. Turn the ignition switch to the ON position using a valid key.
    NOTE:
    • Although the security light remains illuminated and DTC 15 is displayed after approx. 1 min  , continue to perform the procedure as indicated.
  3. Verify that the keyless warning light illuminates for approx. 3 s  , and then turns off.
  4. After vehicle identification, select the following from the M-MDS initial screen.
    • Using an IDS (laptop PC):
      1. Select the "Body".
      2. Select the "Security"
      3. Select the "PATS Functions"
    • Using a PDS (Pocket PC):
      1. Select the "All Tests and Calibrations"
      2. Select the "PATS Functions"
  5. Select "Parameter Reset" from the M-MDS screen menu.
  6. Perform the security access according to the directions on the M-MDS screen. (See SECURITY ACCESS PROCEDURE .)
  7. Select the replaced parts "IC" according to the directions on the M-MDS screen.
    CAUTION:
    • At this time, do not select the other parts from the M-MDS menu.
  8. Verify that the PATS function menu is displayed again on the M-MDS screen.
 Go to the next step.
3 CLEAR IGNITION KEY ID NUMBERS 
  1. Select "Ignition Key Code Erase and Program" from the M-MDS screen menu.
  2. Clear the ignition key ID number according to the directions on the M-MDS.
 Go to the next step.
4 PERFORM IGNITION KEY ID NUMBER PROGRAMMING 
  1. Program two keys according to the directions on the M-MDS.
  2. After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Finish (this menu)".
  3. Turn the ignition switch to the LOCK position.
  4. Turn the ignition switch to the ON position.
  5. Verify that the security light illuminates for approx. 3 s  , and then turns off.
  6. Turn the ignition switch to the LOCK position.
  7. Disconnect the M-MDS from the DLC-2.
 Go to the next step.
5 VERIFY PROGRAMMING IS PERFORMED CORRECTLY 
  1. Verify that the engine can be started with all the keys.
  2. Can the engine be started?
 Yes Procedure is completed
No Perform the corresponding DTC inspection to repair the malfunctioning part.
scientia non olet · About LEMON Manuals