Power Outer Mirror Removal/Installation: Notes

Fully close the front door glass.
NOTE:
- The procedure for routing the wiring harness of the power outer mirror to the backside of the glass guide can be performed smoothly by fully closing the front door glass.
Disconnect the negative battery cable. (Refer to NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
Remove the following parts:
1. Power window main switch (driver-side) (Refer to POWER WINDOW MAIN SWITCH REMOVAL/INSTALLATION .)
2. Power window subswitch (passenger-side) (Refer to POWER WINDOW SUBSWITCH REMOVAL/INSTALLATION .)
3. Front door trim (Refer to FRONT DOOR TRIM REMOVAL/INSTALLATION .)
4. Front door speaker (Refer to FRONT DOOR SPEAKER REMOVAL/INSTALLATION .)
Disconnect the connector.

Fig 1: Identifying Power Outer Mirror Connector
Courtesy of MAZDA MOTORS CORP.
Remove the service hole cover.

Fig 2: Identifying Service Hole Cover
Courtesy of MAZDA MOTORS CORP.
Remove the bolts.

Fig 3: Identifying Power Outer Mirror And Bolts With Torque Specification
Courtesy of MAZDA MOTORS CORP.
Detach the clip.
CAUTION:
- If clip of the power outer mirror is detached, the power outer mirror may fall off and be damaged. When detaching clip of the power outer mirror, hold the power outer mirror by hand during the servicing.
Fig 4: Identifying Front Door Outer Panel And Clip
Courtesy of MAZDA MOTORS CORP.
Pull the power outer mirror in the direction of the arrow while remove the pins.

Fig 5: Pulling Power Outer Mirror
Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal. (Refer to Power Outer Mirror Installation Note .) (Refer to Clip Replacement Note )