Diagnostic Procedure

WARNING: This page is about a different car, the 2018 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.

DTC USUALLY DISPLAYED RELATED FUNCTION DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	INSPECT FOR ANY DTC DISPLAYED SIMULTANEOUSLY Is any DTC not within [] in the DTC table displayed simultaneously?	Yes	Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE (SAS Control Module (Two-step Deployment Control System - US/Canada Spec.)) .)
		No	Go to the next step.
2	VERIFY IF MALFUNCTION CAUSED BY TEMPORARY MALFUNCTION IN SAS CONTROL MODULE Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC (SAS Control Module (Two-step Deployment Control System - US/Canada Spec.)) .) Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC INSPECTION (SAS Control Module (Two-step Deployment Control System - US/Canada Spec.)) .) Are the same DTCs displayed?	Yes	Go to the next step.
		No	DTC troubleshooting completed.
3	VERIFY IF MALFUNCTION CAUSED BY CONFIGURATION ERROR Perform the SAS control module configuration using the M-MDS. (See SAS CONTROL MODULE CONFIGURATION (USING AS-BUILT DATA) [TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.] .) Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC (SAS Control Module (Two-step Deployment Control System - US/Canada Spec.)) .) Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC INSPECTION (SAS Control Module (Two-step Deployment Control System - US/Canada Spec.)) .) Are the same DTCs displayed?	Yes	Re-perform the configuration, then perform the DTC inspection. If the same DTC is displayed, replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.] .)
		No	DTC troubleshooting completed.