Component Modifications -- G-Class (463)
- Component Modifications
- Additional shim between deep-groove ball bearing and output flange - BT27.10-P-0005-01A
- Retaining lug added to electrohydraulic control module - BT27.19-P-0001-01A
- Caps for solenoid valve, new - BT27.19-P-0003-01A
- Pilot bushing modified - BT27.19-P-0004-01A
- Oil drain plug on torque converter deleted - BT27.20-P-0001-01A
- Installation of a pressure feed valve - BT27.35-P-0002-01A
- Strainer for modulating pressure and shift pressure control solenoid valve, new - BT27.35-P-0004-01A
- Strainer in inlet to converter lock-up control solenoid valve, new - BT27.35-P-0005-01A
- Magnet in oil pan, new part - BT27.40-P-0003-01A
- Plain bearing of input shaft changed to an anti-friction bearing - BT27.50-P-0002-02A
- Outer multiple-disc carrier B1 modified - BT27.50-P-0008-01A
- Peak-to-valley height on piston B2 modified - BT27.50-P-0009-01A
- Piston B2 changed - BT27.50-P-0010-01A
- Friction bearing in sun wheel of rear planet gear set converted to anti-friction bearing - BT27.50-P-0011-01A
- Conversion from 18° to 23° gearing in front and rear planetary gear system - BT27.50-P-0012-01A
- End disk modified - BT27.50-P-0015-01W
- Thickness of friction and steel disks K3 changed - BT27.51-P-0001-01A
- Thickness of steel plates of B1, K1 and K2 modified - BT27.51-P-0002-01A
- Additional dished washer in multi-plate set K2 - BT27.51-P-0003-01A
- Center shift modified - BT27.60-P-0001-01A
- Selector lever soldered - BT27.60-P-0002-01A
- Selector lever soldered - BT27.60-P-002-01A