Notes On Remove/Install Rear Window - AH67.20-P-2000-01T

Model 117, 118, 156, 164, 166, 169, 170, 171, 176, 177, 190, 197.3, 202, 203, 204, 205, 207, 209, 210, 211.0/2, 212, 216.3, 217, 218, 219, 222, 230.4, 240, 242, 245.2, 246, 247, 292 

Model 450.3/4, 451.3/4, 452.3/4, 454.0 

The primer must flash off for at least 10 minutes.

Otherwise the adhesive effect of the adhesive material will be impaired.

The side window on the driver door must be open during the adhesive material's curing time.

Otherwise the rear-wall window may be pushed outward by the resulting air pressure when the doors are closed.

The rear-panel window must be positioned within a period of 10 minutes onto the body flange.

Otherwise the adhesive force of the glue starts to decrease.

The areas around the rear-wall window must be masked off with suitable duct tape.

Otherwise there is a risk of damaging the vehicle paintwork when cutting out.

Model 203.0/2

The silicon semi-conductors for ground connection are cut and they must be replaced when installing.

Use new retaining clips when installing water deflector.