Power Steering System Filling
MATERIAL SPECIFICATION
| Item | Specification |
|---|---|
| Motorcraft MERCON Multi-Purpose (ATF) Transmission Fluid XT-2-QDX | MERCON |
WARNING:
Do not mix fluid types. Any mixture or any unapproved fluid could lead to seal deterioration and leaks. A leak can ultimately cause loss of fluid, which can result in a loss of power steering assist.
- Fill the power steering reservoir to the appropriate level.
- Remove the ignition coil fuse number F2-12 in the central junction box to disable the engine from starting.
- Raise the front wheels off the floor. For additional information, refer to JACKING & LIFTING .
- Turn the steering wheel from stop-to-stop while cranking the engine.
- Lower the vehicle.
- Fill the power steering fluid reservoir to the appropriate level.
- Install the ignition coil fuse number F2-12 in the central junction box.
- Clear the diagnostic trouble codes (DTCs). For additional information, refer to the CLEARING CODES .
CAUTION:
Do not operate the starter motor for more than 10 seconds at a time. Damage to the starter motor can result.
CAUTION:
Do not overfill the power steering fluid reservoir.
NOTE:
If the power steering is noisy and accompanied by evidence of aerated fluid it will be necessary to purge the power steering system. For additional information, refer to POWER STEERING SYSTEM PURGING .
- Start the engine and check the system for leaks.