Section 14 (Exterior - Lancer Evolution)
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
- Specification(S)
- Front Bumper Assembly And Radiator Grille
- Rear Bumper Assembly
- Garnishes And Moldings
- Door Sash Tape
- Side Air Dam
- Under Cover
- Rear Spoiler
- Windshield Wiper And Washer
- General Information
- Special Tools
- Windshield Wiper And Washer Diagnosis
- Trouble Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: The windshield wipers do not work at all
- INSPECTION PROCEDURE 2: The windshield wipers do not work when the wiper switch is at the "INT", "Washer" or "Mist" position. However, the wipers work at low speed when the switch is at the "Lo" or "Hi" position
- INSPECTION PROCEDURE 3: Windshield wipers do not stop at the specified park position
- INSPECTION PROCEDURE 4: Windshield Wipers do not work normally
- INSPECTION PROCEDURE 5: The windshield intermittent wiper interval cannot be adjusted by operating the windshield intermittent wiper interval control switch
- INSPECTION PROCEDURE 6: The windshield intermittent wiper interval is not changed according to the vehicle speed
- INSPECTION PROCEDURE 7: The rain sensitive AUTO wiper function does not work at all < Vehicles with lighting control sensor >
- INSPECTION PROCEDURE 8: The rain sensitive AUTO wiper function works even though there is no rainfall < Vehicles with lighting control sensor >
- INSPECTION PROCEDURE 9: Sometimes the rain sensitive AUTO wiper function works even though there is no rainfall < Vehicles with lighting control sensor >
- INSPECTION PROCEDURE 10: The windshield washer does not work normally
- Data List Reference Table
- On-Vehicle Service
- Lighting Control Sensor (Rain Sensor) Inspection
- Configuration Function
- Windshield Wiper
- Inspection
- Windshield Washer
- Lighting Control Sensor
- Adaptation
- Mark
- Door Mirror