>> D << Slide Ball Bearing (For Control Shaft) Installation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Normally, it is not necessary to disassemble the slide ball bearing. Install it only when the transaxle case is replaced with a new one.
Install the bearing with the stamped mark facing upward.

Using special tool, MB990883, install the slide ball bearing (for control shaft) to the new transaxle case.

Fig 1: Identifying Special Tool (MB990883)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.