Test SC-3A - Cruise Control Set/Resume Switch

WARNING: This page is about a different car, the 1995 Eagle Vision, 1995 Dodge Intrepid, and 1995 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform TEST SC-1A before proceeding with this test. After each repair, perform TEST VER-4A .

Disconnect and inspect cruise control SET/RESUME switch. If connector is not okay, repair connector as necessary. If connector is okay, connect a jumper wire between cruise control switch connector terminals No. 1 (Black wire) and No. 2 (White wire). Using scan tool, read cruise control switch voltage. If voltage is less than one volt, replace SET/RESUME switch. If voltage is more than one volt, repair open White wire.