Section 2 (Differentials & Drive Axles)
WARNING: This page is about a different variant/trim than selected.
- General Description
- Rear Axle Diagnosis
- Introduction
- Troubleshooting Strategy
- Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Noise During Wheel Rotation {{Drive Shaft}}
- Inspection Procedure 2: Constant Noise {{Differential}}
- Inspection Procedure 3: Gear Noise While Driving {{Differential}}
- Inspection Procedure 4: Gear Noise While Coasting {{Differential}}
- Inspection Procedure 5: Bearing Noise While Driving Or Coasting {{Differential}}
- Inspection Procedure 6: Noise While Turning {{Differential}}
- Inspection Procedure 7: Heat {{Differential}}
- Inspection Procedure 8: Oil Leakage {{Differential}}
- Special Tools
- On-Vehicle Service
- Rear Axle Hub Assembly
- Knuckle
- Drive Shaft Assembly
- Differential Carrier Assembly
- Removal And Installation
- Differential Mount Bracket Bushing Replacement
- Disassembly
- Notes
- Disassembly Service Points
- <> Inspection Before Disassembly
- <<B>> Differential Case Assembly/Differential Side Bearing Spacer/Differential Side Bearing Outer Race Removal
- <<C>> Differential Side Bearing Inner Race Removal
- <<D>> Drive Gear Removal
- <<E>> Lock Pin Removal
- <<F>> Self-Locking Nut Removal
- <<G>> Drive Pinion Assembly/Companion Flange Removal
- <<H>> Drive Pinion Rear Bearing Inner Race Removal
- <<I>> Oil Seal/Drive Pinion Front Bearing Inner Race/Drive Pinion Front Bearing Outer Race Removal
- <<J>> Drive Pinion Rear Bearing Outer Race Removal
- Assembly
- Notes
- Lubrication And Adhesive Points
- Assembly Service Points
- >>A<< Oil Seal Press-Fitting
- >>B<< Drive Pinion Rear Bearing Outer Race Press-Fitting
- >>C<< Drive Pinion Front Bearing Outer Race Press-Fitting
- >>D<< Drive Pinion Height Adjustment
- >>E<<Drive Pinion Turning Torque Adjustment/Oil Seal Installation
- >>F<< Differential Gear Backlash Adjustment
- >>G<< Lock Pin Installation
- >>H<< Drive Gear Installation
- >>I<< Differential Side Bearing Inner Race Installation
- >>J<< Differential Side Bearing Nut Installation/Snap Ring & Final Drive Gear Backlash Adjustment
- Specifications