Section 43 (Anti-Lock Braking System (Abs))
WARNING: This page is about a different car, the 2004 Mitsubishi Galant. However, it is still accessible from the selected car via links, so may be relevant.
- General Description
- Anti-Lock Braking System (Abs) Diagnosis
- Introduction To Anti-Lock Braking System Diagnosis
- Abs Diagnostic Troubleshooting Strategy
- Diagnostic Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC C1200/C1205/C1210/1215: Wheel Speed Sensor (Open circuit or short circuit)
- DTC C1201/C1206/C1211/1216: Wheel Speed Sensor (Abnormal Output Signal)
- DTC C1226/C1231/C1236/C1241/C1246/C1251/C1256/C1261: ABS Solenoid Valve
- DTC C1266/C1273/C1274: Motor system
- DTC C1278/C1279 Valve Relay System
- DTC C1395: Brake fluid filling not completed
- DTC C1607: Trouble in ABS-ECU
- DTC C1860/C1861: Power supply system (abnormal decrease or increase in voltage)
- DTC U1073: Bus off
- Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: Communication between Scan Tool and the ABS-ECU is not possible.
- INSPECTION PROCEDURE 2: Power Supply Circuit System
- INSPECTION PROCEDURE 3: When the Ignition Key is Turned to "ON" (Engine Stopped), the BRAKE/ABS Warning Light does not Illuminate, INSPECTION PROCEDURE 4: The BRAKE/ABS Warning Light Remains Illuminated after the Engine is Started.
- INSPECTION PROCEDURE 5: Faulty ABS Operation
- Data List Reference Table
- Actuator Test Reference Table
- Check At Abs-Ecu
- Special Tools
- On-Vehicle Service
- Hydraulic Unit
- Wheel Speed Sensor
- Specifications