Technical Description (Comment)
CAUTION:
If the ignition switch is turned to the ON position without starting the engine, DTC (past trouble) 011, 012 and 013 may be set to the combination meter (incorporating meter-ECU) after three minutes.
Current trouble
- Connector(s) or wiring harness in the CAN bus lines between the combination meter and the multi-center display unit (middle grade type), the power supply system to the display unit, the display unit itself, or the combination meter may be defective.
Past trouble
- Carry out diagnosis with particular emphasis on connector(s) or wiring harness in the CAN bus lines between the combination meter and the multi-center display unit (middle grade type), the power supply system to the display unit. For diagnosis procedures, refer to "How to cope with past trouble" (Refer to HOW TO USE TROUBLESHOOTING/INSPECTION SERVICE POINTS ).
NOTE:
For a past trouble, you may not find it by the M.U.T.-III CAN bus diagnostics even if there is any failure in CAN bus lines. In this case, refer to
HOW TO COPE WITH INTERMITTENT MALFUNCTION
). and check the CAN bus lines. You can narrow down the possible cause of the trouble by referring to the DTC, which is set regarding the CAN communication-linked ECUs (Refer to
CAN BUS LINE DIAGNOSTICS FLOW
).