Section 1 (Traction Control System (TCL))
WARNING: This page is about a different variant/trim than selected.
- General Description
- Traction Control System (TCL) Diagnosis
- Introduction To Traction Control System (TCL) Diagnosis
- Troubleshooting Strategy
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- C1396: Engine Torque Intervention Refusal
- C1397: Transmission Range Switch Failure
- U1100: Can Communications System Time Out Error Engine Related Data
- U1101: Can Communications System Time Out Error A/T Related Data
- U1120: Can Communications System TCL Uncontrollable By Engine Malfunction
- U1400: Dynamic Range Error APS1
- Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: When The Ignition Switch Is Turned To The "On" Position (Engine Stopped), The "TCL Off" Indicator Light Does Not Illuminate; Inspection Procedure 2: When The Ignition Switch Is Turned To The "On" Position (Engine Stopped), The TCL Work Indicator Light Does Not Illuminate; Inspection Procedure 3: The "TCL Off" Indicator Light Remains Illuminated After The Engine Is Started; Inspection Procedure 4: The TCL Work Indicator Light Remains Illuminated After The Engine Is Started
- Inspection Procedure 5: When The TCL Switch Is Pushed On, TCL Does Not Cancel
- Inspection Procedure 6: TCL Does Not Operate
- Data List Reference Table
- Actuator Test Reference Table
- Check At Abs/TCL-Ecu Terminal Voltage
- Special Tools
- On-Vehicle Service
- TCL Switch
- Wheel Speed Sensor
- Abs/TCL-Ecu