October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Cruise Control Switch Check
- Remove the cruise control switch (Refer to CRUISE CONTROL SWITCH
.)
- Measure the resistance between terminal number 2 and terminal number 3 when each of the "CRUISE ON/OFF", "CANCEL", "SET-" and "RES+" switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance values are correct.
| Terminal connector of tester |
Switch position |
Specified condition |
| 2 - 3 |
All switches are released. |
Open circuit |
| "CRUISE ON/OFF" switch is pressed |
Continuity (less than 2 ohms) |
| "CANCEL" switch is pressed |
203 - 207 Ω |
| "SET-" switch is pressed |
611 - 623 Ω |
| "RES+" switch is pressed |
1839 - 1875 Ω |
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
- Check that the cruise control switch illuminates when a positive battery terminal is connected to the connector terminal number 4, and terminal number 1 is grounded.