LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2019 >> Outlander LE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Electronic Control Modules (Service Information)) >> Module, HVAC >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, HVAC: Removal

WARNING: This page is about a different car, the 2020 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the Integrated Center Stack (ICS). Refer to MODULE, INTEGRATED CENTER STACK (ICSM), REMOVAL .
    GC0156251Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the wire harness connectors (1) from the Heating, Ventilation and Air Conditioning (HVAC) module.
  4. Remove the fasteners (2) securing the HVAC module.
  5. Remove the HVAC module from the HVAC housing.
scientia non olet · About LEMON Manuals