LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2020 >> Outlander SP, AWD >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Continuously Variable Transaxle (CVT) >> Transaxle Assembly >> Removal And Installation >> Removal Service Points >> <<E>> Engine Assembly Holding
April 5, 2026: LEMON Manuals is launched! Read the announcement.

<<E>> Engine Assembly Holding

  1. Tighten the engine hanger plate (special tool: MB992853) to the specified torque at A in the figure (injector protector rear mounting bolt) and B in the figure (vacuum pipe assembly mounting bolt).

    Tightening torque: 20 ± 2 N.m (15 ± 1 ft-lb) (A in the figure) 

    Tightening torque: 11 ± 1 N.m (98 ± 8 in-lb) (B in the figure) 

    G10224561
  2. Assemble the engine hanger (special tool: MB991527) with the chain of the engine hanger balancer (special tool: MB991454).
    G10230098
  3. Set the foot of special tool engine hanger (MB991895) as shown in the figure.
    NOTE: Slide the front foot of special tool engine hanger attachment (Special tool: MB992906) to balance the engine hanger.
    G10224565
  4. Connect the engine hanger (Special tool: MB991895) to the engine hanger (special tool: MB991527). Remove the garage jack and then remove the transaxle assembly coupling bolts that have been loosened previously.
G10221788
scientia non olet · About LEMON Manuals