Diagnostic Trouble Code Chart
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- During diagnosis, a diagnostic trouble code (DTC) associated with other system may be set when the ignition switch is turned "ON" position with connector(s) disconnected. On completion, confirm all systems for DTC(s). If DTC(s) are set, erase them all.
- When the DTC of the transaxle control module (TCM) is erased, the DTC of the engine control module (ECM) is also erased at the same time.
- If DTC U0001 of the Malfunction of CAN communication circuit (Bus off) or DTC U0100 of the CAN time-out error (Engine) is set as a current trouble to the TCM, CAN bus diagnosis or troubleshooting each DTC should be carried out since the DTC of TCM will not be erased.
| DTC | DIAGNOSTIC ITEM | REFERENCE |
|---|---|---|
| P0703 | Malfunction of brake switch | |
| P0705 | Malfunction of transmission range switch | |
| P0711 | Malfunction of the transmission fluid temperature sensor (range) | |
| P0712 | Malfunction of the transmission fluid temperature sensor (low voltage) | |
| P0713 | Malfunction of the transmission fluid temperature sensor (high voltage) | |
| P0715 | Malfunction of primary pulley speed sensor | |
| P071B | Malfunction of Ds position switch (stuck ON) | |
| P071C | Malfunction of Ds position switch (stuck OFF) | |
| P0720 | Malfunction of output speed sensor | |
| P0741 | Abnormality in lockup function | |
| P0746 | Abnormality in hydraulic control system function | |
| P0791 | Malfunction of secondary pulley speed sensor | |
| P0796 | Abnormality in primary pressure solenoid valve function | |
| P0841 | Abnormality in secondary pressure sensor function | |
| P0842 | Malfunction of the secondary pressure sensor (low voltage) | |
| P0843 | Malfunction of the secondary pressure sensor (high voltage) | |
| P0876 | Malfunction of high clutch oil pressure switch | |
| P0962 | Malfunction of the line pressure solenoid valve (short to ground) | |
| P0963 | Malfunction of the line pressure solenoid valve (open circuit/short to power supply) | |
| P0970 | Malfunction of the primary pressure solenoid valve (short to ground) | |
| P0971 | Malfunction of the primary pressure solenoid valve (open circuit/short to power supply) | |
| P0973 | Malfunction of the low brake solenoid valve (short to ground) | |
| P0974 | Malfunction of the low brake solenoid valve (open circuit/short to power supply) | |
| P0976 | Malfunction of the high clutch and reverse brake solenoid valve (short to ground) | |
| P0977 | Malfunction of the high clutch and reverse brake solenoid valve (open circuit/short to power supply) | |
| P1607 | Malfunction of the system power supply (low voltage) | |
| P1637 | Malfunction of memory backup | |
| P170E | ASC error information | |
| P1797 | G sensor/Brake pressure sensor malfunction | |
| P2763 | Malfunction of the lockup solenoid valve (open circuit/short to power supply) | |
| P2764 | Malfunction of the lockup solenoid valve (short to ground) | |
| P2857 | Auxiliary gearbox gear 1 incorrect ratio run-up | |
| P2858 | Auxiliary gearbox gear 2 incorrect ratio run-up | |
| P2859 | Auxiliary gearbox gear 1 incorrect ratio | |
| P285A | Auxiliary gearbox gear 2 incorrect ratio | |
| U0001 | Malfunction of CAN communication circuit (Bus off) | |
| U0100 | CAN time-out error (Engine) | |
| U0121 | CAN time-out error (ASC) | |
| U0141 | CAN time-out error (ETACS) | |
| U0155 | CAN time-out error (Combination meter) |