Detailed Flow

WARNING: This page is about a different car, the 2023 Mitsubishi Outlander PHEV. However, it is still accessible from the selected car via links, so may be relevant.

INTERVIEW FOR MALFUNCTION
It is important to clarify the customer's concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully.

NOTE: The customers are not professionals. Never assume that "maybe the customer means..." or "maybe the customer mentioned this symptom".

>>

GO TO 2.
DIAGNOSTIC TROUBLE CODE WITH M.U.T.-III SE
With M.U.T-III SE
1. Perform "Read All DTCs" mode.
2. Check if the DTC is detected in the "Diagnostic Trouble Code" of the following:
  - "ICC/ADAS 2"
  - "LASER/RADAR"
  - "LANE CAMERA"
  - "Side radar (Rear left")
  - "Side radar (Rear right")
  Is any DTC detected?
  
  YES >>
  
  GO TO 5.
  
  NO >>
  
  GO TO 3.
ACTION TEST
1. Perform the system action test to check the operation status of the following:
  - LDW: Refer to INSPECTION PROCEDURE .
  - LDP: Refer to INSPECTION PROCEDURE .
  - BSW: Refer to WORK PROCEDURE .
  - Active Blind Spot Assist [ABSA]: Refer to WORK PROCEDURE .
  - TSR: Refer to WORK PROCEDURE .
  - RCTA: Refer to WORK PROCEDURE .
  - DAA: Refer to WORK PROCEDURE .
2. Check if any other malfunctions occur.
>>

GO TO 4.
SYMPTOM DIAGNOSIS
Perform the applicable diagnosis according to the diagnosis chart by symptom. Refer to SYMPTOM TABLE .

>>

GO TO 6.
TROUBLE DIAGNOSIS BY DTC
With M.U.T.-III SE
1. Check the DTC in the "Diagnostic Trouble Code".
2. Perform trouble diagnosis for the following detected DTC:
  - "ICC/ADAS 2": Refer to DTC INDEX .
  - "LASER/RADAR": Refer to DTC INDEX .
  - "LANE CAMERA": Refer to DTC INDEX .
  - "Side radar (Rear left"): Refer to DTC INDEX .
  - "Side radar (Rear right"): Refer to DTC INDEX .
  NOTE: If Network-DTC is detected, first diagnose the CAN communication system.
  
  >>
  
  GO TO 6.
MALFUNCTIONING PART REPAIR
Repair or replace the identified malfunctioning parts.

>>

GO TO 7.
REPAIR CHECK (DIAGNOSTIC TROUBLE CODE WITH M.U.T.-III SE)
1. Erase "Diagnostic Trouble Code".
2. Perform "Read All DTCs" mode after repairing or replacing the specific items.
3. Check if any DTC is detected in Diagnostic Trouble Code results of the following:
  - "ICC/ADAS 2"
  - "LASER/RADAR"
  - "LANE CAMERA"
  - "Side radar (Rear left")
  - "Side radar (Rear right")
  Is any DTC detected?
  
  YES >>
  
  GO TO 5.
  
  NO >>
  
  GO TO 8.
REPAIR CHECK (ACTION TEST)
Perform the following system action test. Check that the malfunction symptom is solved or no other symptoms occur.
- LDW: Refer to INSPECTION PROCEDURE .
- LDP: Refer to INSPECTION PROCEDURE .
- BSW: Refer to WORK PROCEDURE .
- Active Blind Spot Assist [ABSA]: Refer to WORK PROCEDURE .
- TSR: Refer to WORK PROCEDURE .
- RCTA: Refer to WORK PROCEDURE .
- DAA: Refer to WORK PROCEDURE .
Is there a malfunction symptom?

YES >>

GO TO 4.

NO >>

Inspection End.