DTC Confirmation Procedure

WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Always drive vehicle at a safe speed.
Be careful not to rev engine into the red zone on the tachometer.

NOTE: If DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE has been previously performed, always turn ignition switch OFF and wait at least 5 seconds before performing the next test.

After the repair, touch ERASE on SELF-DIAG RESULTS and then perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-II

Turn ignition switch ON and select DATA MONITOR mode for ENGINE with CONSULT-II.

Fig 1: CONSULT-II ENGINE Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Start engine and maintain the following conditions for at least 5 consecutive seconds.
VHCL SPEED SE: 10 km/h (6 MPH) or more

ACC PEDAL OPEN: More than 1/8

Selector lever: D position

ENG SPEED: 450 rpm or more

Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.

If the check result is NG, go to DIAGNOSTIC PROCEDURE .

Fig 2: CONSULT-II SELECT-DIAG MODE Display
Courtesy of NISSAN MOTOR CO., U.S.A.

WITH GST

Follow the procedure, With CONSULT-II.