DTC Confirmation Procedure

WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Always drive vehicle at a safe speed.
Be careful not to rev engine into the red zone on the tachometer.

NOTE: If DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE has been previously performed, always turn ignition switch OFF and wait at least 5 seconds before performing the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

With CONSULT-II

Turn ignition switch ON and select DATA MONITOR mode for TRANSMISSION with CONSULT-II.

Fig 1: CONSULT-II TRANSMISSION Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Start engine and maintain the following conditions for at least 12 consecutive seconds.
VHCL SPEED: 40 km/h (25 MPH) More than

Selector lever: D position

If the check result is NG, go to DIAGNOSTIC PROCEDURE .

Fig 2: CONSULT-II SELECT DIAG MODE Display
Courtesy of NISSAN MOTOR CO., U.S.A.