Error item
Some error items may be displayed simultaneously according to the cause. If some error items are displayed simultaneously, the detection of the cause can be performed by the combination of display items
ITEM DESCRIPTION
| Error item | Description | Possible malfunction factor/Action to take |
|---|---|---|
| CAN COMM CIRCUIT | CAN communication malfunction is detected. | Perform diagnosis with CONSULT-III, and then repair the malfunctioning parts according to the diagnosis results. Refer to "CONSULT-III FUNCTION (MULTI AV) ". |
| CONTROL UNIT (CAN) | CAN initial diagnosis malfunction is detected. | Replace the AV control unit if the malfunction occurs constantly. |
| CONTROL UNIT (AV) | AV communication circuit initial diagnosis malfunction is detected. | |
| FLASH-ROM Error Of Control Unit | AV control unit malfunction is detected. | |
| Connection Of Gyro | ||
| Connection of G Sensor | ||
| CAN Controller Memory Error | ||
| Bluetooth Module Connection Error | ||
| Sub CPU Connection Error | ||
| iPod authentification chip error | ||
| Audio connection error | ||
| DSP Connection Error | AV control unit malfunction is detected. |
|
| DSP Communication Error | ||
| HDD Connection Error | AV control unit malfunction is detected. |
|
| HDD Read Error | ||
| HDD Write Error | ||
| HDD Communication Error | ||
| HDD Access Error | ||
| GPS Communication Error | GPS malfunction is detected. | An intermittent error caused by strong radio interference may be detected unless any symptom (GPS reception error, etc.) occurs. Replace the AV control unit if the malfunction occurs constantly. |
| GPS ROM Error | ||
| GPS RAM Error | ||
| GPS RTC Error | ||
| Unfinished configuration | The writing of configuration data is incomplete. | Write configuration data with CONSULT-III. |
| USB Controller Communication Error | USB connection malfunction is detected. | Check that the connection to the USB connector is normal. |
| DVD Mechanism Communication Error | AV control unit malfunction is detected. |
|
| USB electric current Error | Detection of over current in USB interface. | Check USB harness between the AV control unit and USB interface. |
| GPS Antenna Error | GPS antenna connection malfunction is detected. | Check the connection of the GPS antenna connector. |