Inspection Procedure

Turn ignition switch OFF.
Connect "GST" to data link connector (1), which is located under LH dash panel.
Turn ignition switch ON.

Fig 1: Identifying Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Enter the program according to instruction on the screen or in the operation information.
(*: Regarding GST screens in this article, sample screens are shown.)

Fig 2: GST Display - Sample Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Perform each diagnostic mode according to each service procedure.
For further information, see the GST Operation Information of the tool maker .

Fig 3: GST Screens Display - Readiness Tests
Courtesy of NISSAN MOTOR CO., U.S.A.