LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2010 >> Rogue SL, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (MEXICO) >> DTC/Circuit Diagnosis >> DTC P2135: TP Sensor >> Component Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

  1. CHECK THROTTLE POSITION SENSOR
    1. Turn ignition switch OFF.
    2. Reconnect all harness connectors disconnected.
    3. Perform , "THROTTLE VALVE CLOSED POSITION LEARNING : SPECIAL REPAIR REQUIREMENT ".
    4. Turn ignition switch ON.
    5. Set selector lever to the D position.
    6. Check the voltage between ECM harness connector terminals.
    VOLTAGE SPECIFICATION

    ECM Condition Voltage
    + -
    Connector Terminal Connector Terminal
    F8 37 (TP sensor 1 signal) F8 36 (Sensor ground) Accelerator pedal Fully released More than 0.36 V
    Fully depressed Less than 4.75 V
    38 (TP sensor 2 signal) Fully released Less than 4.75 V
    Fully depressed More than 0.36 V

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: GO TO 2.

  2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
    1. Replace electric throttle control actuator.
    2. Perform , "SPECIAL REPAIR REQUIREMENT ".

    INSPECTION END

scientia non olet · About LEMON Manuals