Remove & Install or Remove & Replace
WARNING: This page is about the Sentra Base, Automatic CVT, which is a different variant/trim than selected.
NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Both | 1.6 | 0.7 | B | |
| Left Side | 0.8 | 0.4 | B | |
| Right Side | 1.0 | 0.5 | B | |
| Combination Procedure: AXLE SHAFT: Replace: NOTE: For Independent Suspension Type Axles, this operation consists of dissassembly and reassembly of the Axle Shaft Assembly and replacement of the Axle Shaft. | ||||
| Each | 1.0 | B | ||
| Combination Procedure: AXLE SHAFT BOOT: Replace: | ||||
| Inner &/or Outer,Each Side | 1.0 | B | ||
| Combination Procedure: AXLE SHAFT CENTER SUPPORT BEARING: Replace: | ||||
| 0.3 | B | |||
| Combination Procedure: AXLE SHAFT JOINT: Replace: | ||||
| Each | 0.5 | B | ||
| Combination Procedure: DIFFERENTIAL SIDE SEAL: Replace: | ||||
| Each | 0.2 | B | ||