Service After Replacing TCM, Transaxle Assembly, Or Control Valve
Perform the applicable service according to the following table when replacing TCM, transaxle assembly, or control valve.
CAUTION:
- Never start the engine until the service is completed.
- "DTC P1701" may be indicated soon after replacing TCM, or transaxle assembly or control valve (after erasing the memory in the pattern B). Restart the self-diagnosis after erasing the self-diagnosis result using CONSULT-III. Check that no error is detected.
TCM CHART
| TCM | Transaxle assembly or control valve | Service pattern |
|---|---|---|
| Replaced with new unit | Not replaced the unit | "PATTERN A" |
| Not replaced the unit | Replaced with new or old unit | "PATTERN B" |
| Replaced with old unit | Not replaced the unit | |
| Replaced with new or old unit | ||
| Replaced with new unit | Replaced with new or old unit | "PATTERN C" |
NOTE:
Old unit means that the unit has been already used for another vehicle.