Diagnostic Test: System Links
WARNING: This page is about a different car, the 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Check the vehicle battery condition first.
- Verify that the correct audio-navigation unit is installed for this model. Go into the Diagnostic mode, and use VERSION .
- Check the connectors for poor connections or loose terminals.
- Before troubleshooting, make sure you have anti-theft code for the navigation system.
- After troubleshooting, enter the anti-theft code for the navigation system if necessary.
- Make sure that the correct DVD color and version are installed.
- Inspect the DVD for dirt or damage (see HOW TO IDENTIFY NAVIGATION DVD VERSIONS, AND HOW TO INSPECT A DVD FOR DAMAGE ).
- Check any official Honda service website for more service information about the navigation system.
- Turn the ignition switch to ON (II).
- Check if the navigation system can control the audio and disc functions properly.
Can the navigation system control the audio and disc functions properly?
YES - Intermittent failure, the system is OK at this time.
NO - Go to step 3.
- Go into the Diagnostic mode, and select the Self-Diagnosis Mode diagnostic (see SYSTEM DIAGNOSTIC MODE
).
Is the Radio icon red?
YES - Do the Audio unit power switch will not turn on (no information display and no sound) (with navigation) troubleshooting (see AUDIO UNIT POWER SWITCH WILL NOT TURN ON (NO INFORMATION DISPLAY AND NO SOUND) (WITH NAVIGATION) ).
NO - Substitute a known-good audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ) and recheck. If the symptom gone, replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).