Component Inspection

1. Turn ignition switch OFF.
2. Disconnect combination switch (spiral cable) harness connector.
3. Check resistance between combination switch harness connector terminals under the following conditions.

   Combination switch		Condition	Resistance (Ohm)
   Connector	Terminals
   M303	13 and 16	MAIN switch: Pressed	Approx. 0
   		CANCEL switch: Pressed	Approx. 250
   		SET/COAST switch: Pressed	Approx. 660
   		RESUME/ACCELERATE switch: Pressed	Approx. 1, 480
   		All ASCD steering switches: Released	Approx. 4, 000

Is the inspection result normal?

YES

INSPECTION END

NO

Replace ASCD steering switch