LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2020 >> 370Z Base, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Diagnostics) (2 Of 2) >> Component/Circuit Diagnosis >> Camshaft Position Sensor >> Component Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

  1. CHECK CAMSHAFT POSITION SENSOR (PHASE)-I 
    1. Turn ignition switch OFF.
    2. Loosen the fixing bolt of the sensor.
    3. Disconnect camshaft position sensor (PHASE) harness connector.
    4. Remove the sensor. Refer to TIMING CHAIN : Exploded View .
    5. Visually check the sensor for chipping.
      GNSJMBIA0065Z-065Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES

    GO TO 2.

    NO

    Replace malfunctioning camshaft position sensor (PHASE).

  2. CHECK CAMSHAFT POSITION SENSOR (PHASE)-II 

    Check resistance camshaft position sensor (PHASE) terminals as follows.

    Terminals (Polarity)

    Resistance (Ohm)

    1 (+) - 2 (-)

    Except 0 or INF. [at 25 deg. C (77 deg. F)]

    1 (+) - 3 (-)

    2 (+) - 3 (-)

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Replace malfunctioning camshaft position sensor (PHASE).

scientia non olet · About LEMON Manuals