Component Inspection

1. Turn ignition switch OFF.
2. Disconnect engine coolant temperature sensor harness connector.
3. Remove engine coolant temperature sensor.
4. Check resistance between engine coolant temperature sensor terminals by heating with hot water as shown in the figure, below.

   Courtesy of NISSAN NORTH AMERICA, INC.

   Terminals	Condition		Resistance (k Ohm)
   1 and 2	Temperature [ deg. C (deg. F)]	20 (68)	2.10 - 2.90
   		50 (122)	0.68 - 1.00
   		90 (194)	0.236 - 0.260

Is the inspection result normal?

YES

INSPECTION END

NO

Replace engine coolant temperature sensor.