Component Function Check

When S-MODE switch is pressed (less than 1 second), S-MODE indicator illuminates, combination meter sends S-MODE switch signal to ECM via the CAN communication, and then SynchroRev Match mode (SMODE) is activated. When S-MODE is pressed and held (1 second or more), S-MODE indicator turns OFF and S-MODE is cancelled, and then returns to normal M/T.

1. CHECK S-MODE SWITCH FUNCTION-I 
   NOTE: If DTC UXXXX are displayed, first perform the trouble diagnosis for DTC UXXXX.
   1. Turn ignition switch ON.
   2. Select "M/T SYNCHRO SW" in "DATA MONITOR" mode with CONSULT.
   3. Check "M/T SYNCHRO SW" indication under the following conditions.

      Monitor item	Condition		Indication
      M/T SYNCHRO SW	S-MODE switch	Pressed	ON
      		Released	OFF

   Is the inspection result normal?

   YES

   GO TO 2.

   NO

   Refer to Diagnosis Procedure .

2. CHECK S-MODE SWITCH FUNCTION-II 

   Check the S-MODE indicator under the following condition.

   Condition		S-MODE indicator
   S-MODE switch	Press (less than 1 second)	Illuminated
   	Press (1 second or more)	Not illuminated

   Is the inspection result normal?

   YES

   INSPECTION END

   NO

   Refer to Diagnosis Procedure .