Component Inspection
- CHECK THROTTLE POSITION SENSOR
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Refer to Work Procedure .
- Turn ignition switch ON.
- Set selector lever to D (A/T) or 1st (M/T) position.
- Check the voltage between ECM harness connector terminals as per the following.
ECM
Condition
Voltage (V)
Connector
+
-
Terminal
Terminal
F111
71 [TP sensor 1 (bank 1)]
75
Accelerator pedal
Fully released
More than 0.36
Fully depressed
Less than 4.75
82 [TP sensor 1 (bank 2)]
95
Fully released
More than 0.36
Fully depressed
Less than 4.75
72 [TP sensor 2 (bank 1)]
75
Fully released
Less than 4.75
Fully depressed
More than 0.36
81 [TP sensor 2 (bank 2)]
95
Fully released
Less than 4.75
Fully depressed
More than 0.36
Is the inspection result normal?
YES
INSPECTION END
NO
GO TO 2.
- REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
Replace malfunctioning electric throttle control actuator. Refer to INTAKE MANIFOLD COLLECTOR : Exploded View .
INSPECTION END