Work Procedure: Notes

When the control unit is replaced, the initialization is necessary.

If any of the following operations are performed, the initialization is necessary and the control unit must be disconnected.

• Power supply to the power window switch or power window motor is cut off by removal of battery terminal or if the battery fuse is blown.
• Disconnection and connection of power window switch harness connector.
• Removal and installation of motor from regulator assembly.
• Operation of regulator assembly as an independent unit.
• Removal and installation of door glass or door glass run.

The following specified operations cannot be performed under the non initialized condition.

• Auto-up operation
• Anti-pinch function
• Key cylinder switch power window function
• Automatic window adjusting function
• Auto-up, manual-up does not operate when door is open