Power Supply Position Change Table By Push-Button Ignition Switch Operation
WARNING: This page is about a different car, the 2020 Infiniti QX50. However, it is still accessible from the selected car via links, so may be relevant.
The power supply position changing operation can be performed with the following operations.
NOTE:
- When an Intelligent Key is within the detection area of inside key antenna and when Intelligent Key backside is contacted to push-button ignition switch, it is equivalent to the operations below.
- When starting the engine, the BCM monitors under the engine start conditions:
- Brake pedal operating condition
- Selector lever position
- Vehicle speed
Vehicle speed: less than 4 km/h (2.5 MPH)
|
Power supply position |
Engine start/stop condition |
Push-button ignition switch operation frequency |
|
|
Selector lever position |
Brake pedal condition |
||
|
OFF => ON |
-- |
Released |
1 |
|
OFF => ON => OFF |
-- |
Released |
2 |
|
OFF => START ON => START |
P (Park) or N (Neutral) |
Depressed |
1 |
|
Engine is running => OFF |
-- |
-- |
1 |
Vehicle speed: 4 km/h (2.5 MPH) or more
|
Power supply position |
Engine start/stop condition |
Push-button ignition switch operation frequency |
|
|
Selector lever position |
Brake pedal condition |
||
|
Engine is running => OFF |
-- |
-- |
Emergency stop operation |
|
Engine stall return operation while driving |
N (Neutral) |
Released |
1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.