LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2020 >> Sentra S >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Basic Inspection >> Stall Test >> Work Procedure >> Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Work Procedure: Inspection

  1. Check the engine oil level. Replenish if necessary. Refer to Inspection .
  2. Check for leak of the CVT fluid. Refer to Inspection .
  3. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80 deg.C (122 to 176 deg.F).
  4. Be sure to apply the parking brake and block the tires.
  5. Start the engine, depress the brake pedal and put the selector lever to the D position.
  6. While depressing the brake pedal, depress the accelerator pedal gradually.
  7. Read the stall speed quickly. Then, release your foot from the accelerator pedal quickly.
    CAUTION: Do not depress the accelerator pedal for 5 seconds or more during the test.

    Stall speed

    : Refer to Stall Speed .
  8. Place the selector lever in the N position.
  9. Cool the CVT fluid.
    CAUTION: Run the engine with the idle speed for at least 1 minute.
  10. Put the selector lever to the R position and perform Step 6 to Step 9 again.
scientia non olet · About LEMON Manuals