Detailed Flow
- INTERVIEW FOR MALFUNCTION
It is important to clarify the customer's concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully.
NOTE: The customers are not professionals. Never assume that "maybe the customer means..." or "maybe the customer mentioned this symptom".GO TO 2.
- SELF-DIAGNOSIS WITH CONSULT
CONSULT
- Perform "All DTC Reading" mode.
- Check if the DTC is detected in the "Self Diagnostic Result" of the following:
- "ICC/ADAS 2"
- "LASER/RADAR"
- "LANE CAMERA"
- "Side radar (Rear left)"
- "Side radar (Rear right)"
Is any DTC detected?
YES
GO TO 5.
NO
GO TO 3.
- ACTION TEST
- Perform the system action test to check the operation status of the following:
- LDW: Refer to Work Procedure .
- BSW: Refer to Work Procedure .
- RCTA: Refer to Work Procedure .
- I-DA: Refer to Work Procedure .
- TSR: Refer to Work Procedure .
- Check if any other malfunctions occur.
GO TO 4.
- Perform the system action test to check the operation status of the following:
- SYMPTOM DIAGNOSIS
Perform the applicable diagnosis according to the diagnosis chart by symptom. Refer to Symptom Table .
GO TO 6.
- TROUBLE DIAGNOSIS BY DTC
CONSULT
- Check the DTC in the "Self Diagnostic Result".
- Perform trouble diagnosis for the following detected DTC:
NOTE: If "DTC U1000" is detected, first diagnose the CAN communication system or ITS communication system.GO TO 6.
- MALFUNCTIONING PART REPAIR
Repair or replace the identified malfunctioning parts.
GO TO 7.
- REPAIR CHECK (SELF-DIAGNOSIS WITH CONSULT)
- Erase "Self Diagnostic Result".
- Perform "All DTC Reading" mode after repairing or replacing the specific items.
- Check if any DTC is detected in self-diagnosis results of the following:
- "ICC/ADAS 2"
- "LASER/RADAR"
- "LANE CAMERA"
- "Side radar (Rear left)"
- "Side radar (Rear right)"
Is any DTC detected?
YES
GO TO 5.
NO
GO TO 8.
- REPAIR CHECK (ACTION TEST)
Perform the following system action test. Check that the malfunction symptom is solved or no other symptoms occur.
- LDW: Refer to Work Procedure .
- BSW: Refer to Work Procedure .
Is there a malfunction symptom?
YES
GO TO 4.
NO
Inspection End.